There are a few places you can find asbestos in a building; Cement, coatings, floor tiles, insulating boards, lagging and loose. Buildings constructed before 1999 will most likely contain at least one form of asbestos that may have been too expensive/ difficult to remove.

Asbestos filled cement can often be found in the form of guttering, wall cladding and roofing. It is most commonly used for corrugated cement roofing which can be found on old farm buildings, warehouses and on some private sheds and garages.

Plenty of ceilings and walls in older buildings were coated in asbestos by either spraying or a textured coating, this existed in lofts, living spaces and around beams. Textured coatings are often quite stable but sprayed coatings have the highest asbestos content so even a small disturbance could release vast quantities into the air.

Tiles made of asbestos were often used in insulating floor surfaces underneath laminate flooring or carpets. Similar forms of the material were used in fire blankets and oven gloves. Although generally quite safe to work with it is still best to consult a specialist or guidelines.

Fireproofing with asbestos insulating board (AIB) was quite common and this often existed in partition walls, fire doors, lift shafts and roof lining. Large quantities of this can be found in many buildings from the 50s-90s and it is considered very dangerous to work with. It should be handled by a fully licensed contractor.

Loose fill and lagging asbestos are considered the most dangerous forms of the material and are often found in cavities and wrapped around pipes and boilers. Both of these are the most dangerous and should only be handled by a professional as they can easily release toxins into the air.

Want to know if you can make a claim for exposure to asbestos then visit the ‘whats-my-claim-worth’ site for advice on your rights.

There is something special when you are invited to a friends house and you find the floors are heated and warm. Installing radiant heated floors is something most of us would like to do but will never get around to doing. Not only is the cost somewhat prohibitive but also the idea of ripping up your floors to get under them sounds like too much trouble to most people.

On the rare occasions when radiant heat is installed in a home, it is most often found in the kitchen or master bathroom. Generally, it is the high-end homes that this option may be available. It is the expense, and installation headaches that will keep most homeowners from ever experiencing the enjoyment of radiant heat in their homes.

Your interest in heated floors may well appeal to you after a harsh winter of heating your home with dry heat. One of the greatest advantages of radiant heat is that the heat stays in the specified room without blowing all over the house. You will find that your skin doesn’t dry out as bad because the heat just softly rises. Because radiant heat makes no noise, you will not experience any bothersome racket at all.

The cost of installation makes radiant heat a rarity in homes. Radiant heat doesn’t fall in line with homebuilders’ desire to keep construction costs low. So, as homeowners, most of us will never have the opportunity to enjoy the benefits of radiant heat.

Two of the main considerations when exploring the possibility of radiant heat is the cost of installation and your budget. Trying to heat your home with radiant heat, either electric or hydronic, can be prohibitively expensive. This is why most homeowners reserve the luxury for the rooms where the family will spend the most time. Using dry heat all winter can really do a number on your skin, and the fact that radiant heat won’t dry your skin out is one of its’ greatest benefits. In fact, you can’t even begin to compare traditional heat to radiant heat until you have experienced each.

Are you hoping to learn about radiant ceiling heat? If you are please visit my website Radiant Heat Floors to find out more.

categories: heating,heat,diy,construction,building,skin care